View full version: IDI Engine
  1. That Smell
  2. bad vibrations...... and no TDC mark on flywheel...
  3. is this still a good donor for a 11mm pump swap?
  4. Timing question
  5. can you install an injection pump turbo top to a na lower half?
  6. bad starter on 1.9TD
  7. kkk or garette ?
  8. no diesel out of injector lines after pump rebuild
  9. North America's First Turbo Diesel VW Fox
  10. Poll: Convinced into a state of uncertainty
  11. K24 Question
  12. cold start coolant temp sensor
  13. Motor Serial Numbers
  14. Lots of clatter from 10mm hybrid pump on franken motor
  15. aaz fuel filter question
  16. looking at this mk1 (L version)..... thoughts?
  17. Air cleaner suggestions wanted
  18. Coolant filter
  19. Buzzing Noise AAZ vanagon
  20. Injection pump timing on a 1.6/1.9 franken engine
  21. aaz why not remove the balancer from the sprocket?
  22. Rebuilding an IP
  23. Head gasket job time
  24. Rebuilt turbo now bluish white smoke, bad news?
  25. 1.9 head porting pictures anyone?
  26. pulse time AAZ?
  27. freshening up an aaz for vanagon install, lots of questions !
  28. Torque/Power on Boost
  29. Drunk Valve
  30. Used TTY (stretch) cyl head bolts- how much do they stretch?
  31. Badly corroded radiator and aux fan switch
  32. Where does this piece go?
  33. removing vacuum pump
  34. Tore the head down finally
  35. blue ring seals on inlet manifold gasket, where should it touch?
  36. camshaft belt tensioner locknut torque is 33 ft lbs???
  37. true or false?
  38. Ultra Low Sulfur
  39. OOPS POO BOX build..
  40. Adjusting valves
  41. a wooden timing plug tool
  42. Stiff/stuck cold start advance lever
  43. WVO/WMO filter plan
  44. Help Changing coolant
  45. Found .020 longer valves (OAL) in my head?
  46. stock 1.6td only seeing 5-7 PSI
  47. Does the motor mount have to come off first to remove turbo drain line?
  48. TTY head bolt and block hole prep
  49. How to clean block deck?
  50. Forcing air into my 1.6 NA then going into a MK3