View full version: IDI Engine
  1. 4 rabbits in NH
  2. Should I worry about fine "mist" of bubbles in return line?
  3. My first 1.6TD rebuild...
  4. the values presented by the temp sensor
  5. AAZ clutch size
  6. Easiest power modification
  7. So I lost 5th gear tonight,
  8. 6 speed vr tranny on idi motor?
  9. high speed death
  10. Fuel Line routing?
  11. Water separator & filter MK2 1992 Jetta ECOdiesel
  12. How do you press in a new passenger side engine mount in a MKI?
  13. Exhaust manifold torque specs
  14. OIL GALLEY PLUGS
  15. Factory intake/air box design
  16. will a 16V pump-head-oil cooler hose fit an AAZ?
  17. Engine Removal
  18. timing belt tricks?
  19. Thoughts and ideas needed
  20. Which NA air box/intake is better?
  21. 1.8t intercooler on mk2 td
  22. 1.6/1.9TD Franken: Max Boost?
  23. Turbo Setup suggestions for 1.5/TurboBlock/1.9 head Franken engine.
  24. 1.6 TD questions
  25. off the line acceleration
  26. k03 turbine shaft question
  27. Long rubber hose to boost gauge - curious
  28. Compound turbos on a 1.9td
  29. delete blow off valve on manifold, using K14 turbo?
  30. To remove or not to remove................
  31. r&r passenger MKI motor mount
  32. Audi 5cyl / Volvo D24 - crank damper tool, same?
  33. ARP Studs (11 mm) Torque confusion
  34. Head questions
  35. ...............
  36. 1.6 na exhaust replace
  37. Port/Polish brand new head
  38. car running cooler after cetane addatives?
  39. grit for ball hone
  40. HOW is it possible for these to flow any better than a stock TD piece?
  41. r&r heater core 81 caddy tricks?
  42. Engine dimensions
  43. Removing and replacing valve stem seals
  44. What is the purpose of this part on the diaphram vacuum pump?
  45. Oil System Upgrade
  46. 5 Speed Gas 1.7 Tranny in a 1.6 Diesel
  47. 1.9TD pump on a 1.6TD
  48. Accelerator question
  49. GT2056V on a 1.6TD...
  50. AAZ 'split-ring' IP