- High speed vibrations, you tell me why
- it's alive but smokey
- Another non-start thread, no fuel in injector return lines
- My no start issue, LOW COMPRESSION!!!!!! New diagnosis!!!!!!
- It never ends, now the injector returns are leaking.
- Starting issue
- trying to put ammeter on vanagon
- Pulsing clear fuel line
- ARGH...overheating...
- Aaz serp belt path???
- IP Leaking after rebuild
- alternator pulley & fan removal
- Timing 1.6TD
- Thread locker on Oil Pan Bolts?
- Oil Dip Stick Tube Removal
- 1991 1.6TD, severe starting issues
- Does air in fuel lines affect economy?
- 94 AQAZ 1.9 Jetta....long idle times ok?
- poor headlights
- Is it possible for lda starwheel/pin adjustment to cause these major problems?
- Does not start, HELP
- giles rebuilt my vanagon IP
- Need Help Putting Passenger Side CV Assembly Back In!! Please
- Back to the experts (electrical)
- My Ball joint is too loose on new spindle What size ball joint do I need? Help!!
- Intermittent ticking then clacking of an injector (solved)
- Low Coolant Sensor
- Garret T3 oil return leak
- Flywheel threadlocker?
- Shifter Relay Lever
- 020 trans fluid level check.
- Speedo Screw Removal
- I am thinking of a word that starts with the letter F
- grrrrr now my brakes are failing.........
- No hot start (IDI)
- Challenge: Solve the mystery of my front end knock.
- Brake pressure Regulator repair/replace
- rotary vacuum pump clicking unevenly, have brakes and oil pressure.
- standard exhaust size?
- reverse gear keeps poping out.
- Speedo Issue
- It suddenly stopped sucking fuel, fixed.
- trans drain plug thread pitch?
- runs rough under 1/4 tank
- My starter groans sometimes
- Rotory vac pump not working, oil pumps fault
- Clutch release plate
- Wastegate initial setup?
- Hub cap clips, how to install
- No fuel in cold - filter probs (IDI)