I've got a longblock that has low compression. Any suggestions on what the potential problem could be? Unfortuantely, to keep my project moving I sent all my components to be installed on a new rebuilt engine. So I'm not sure what tests I can run any tests.
Dave
Do you have the injection pump still? If you have the timing belt installed I'm pretty sure you can do all the checks you need to to figure it out
make sure you have the right size for compression test unit, lot's on ebay and once you pull the injectors out, you need to replace the heat shields....
disconnect the GP harness, and Fuel shut off solenoid ( hard to start when the motor is running purley of compression) and crank the motor