-
#60
by
RabbitJockey
on 22 May, 2017 09:57
-
also, i would try to find the fuel line clamps to help prevent them from vibrating and breaking.
I think the electronics on the pump controls the timing advance and timing, kind of like the solenoid on some injection pump timing covers. but i am not sure.
-
#61
by
RockOcean
on 22 May, 2017 11:48
-
I don't have the belt for that set up. I would also have to put on the power steering pump, and a/c compressor to get that to work.
-
#62
by
Gizmoman
on 22 May, 2017 20:04
-
Sounds like your real close!
Congrats on getting it in already. I find that setbacks can be good just to keep things going at a logical pace
-
#63
by
RockOcean
on 22 May, 2017 20:15
-
I ordered the factory no a/c, no power steering water pump pulley from VW today. Will be here tomorrow along with my old turbo with the correct oil feed adapter on it. Here is a picture of the insane cylinder wall wear on number 4. I don't know how it still ran so well and started up fine with that much wear? Any thoughts on what made it wear like this?
#4CylinderWear by
RockOcean.com, on Flickr
-
#64
by
RabbitJockey
on 22 May, 2017 21:19
-
headgasket or injector? maybe a bad oil squirter in that cylinder?
-
#65
by
ORCoaster
on 22 May, 2017 21:45
-
What condition were the rings when you removed them? Almost looks like metal on the top of the cylinder wall. Heat issue?
-
#66
by
TylerDurden
on 23 May, 2017 07:13
-
I'm guessing fuel wash or ingested debris.
-
#67
by
RabbitJockey
on 23 May, 2017 09:11
-
reading over the entire thread it sounds like a lot of dirt did get in the engine, and if you look the other bores are very worn out for a relatively fresh engine so that would make sense.
-
#68
by
RockOcean
on 23 May, 2017 17:33
-
Woooohoooo started right up! Time for a 100 mile test run. Thanks everyone for all your help :~ )
-
#69
by
libbydiesel
on 23 May, 2017 19:49
-
Nice! I'd ditch the K&N and get a filter that doesn't pass the fine dust.
-
#70
by
Gizmoman
on 23 May, 2017 22:20
-
Nice! I'd ditch the K&N and get a filter that doesn't pass the fine dust.
^^^^
That thars melted aluminium - seen it (but a lot worse).
-
#71
by
RabbitJockey
on 24 May, 2017 07:44
-
K&N=snakeoil
-
#72
by
Gizmoman
on 24 May, 2017 16:06
-
-
#73
by
RockOcean
on 24 May, 2017 16:13
-
So what cone filter company do you recommend?
Sent from my SM-G925V using Tapatalk
-
#74
by
Gizmoman
on 24 May, 2017 16:30
-