-
parting 85 1.6 TD engine
by
ilikevwdiesel
on 19 Mar, 2013 04:13
-
parting an MF 1.6 with solid lifers. keeping the turbo and associated parts, everything else must go. pm with needs.
-
#1
by
ilikevwdiesel
on 20 Mar, 2013 17:23
-
cylinder head sold. still have the pump, going to install it on my rabbit truck to test it. looking for 150 for that if it tests good.
-
#2
by
Rising
on 20 Mar, 2013 20:31
-
how much for the oil pan shipped to 22554? or is that going with the turbo set up?
-
#3
by
DRP67207
on 21 Mar, 2013 11:18
-
PM Sent
-
#4
by
ilikevwdiesel
on 21 Mar, 2013 12:52
-
regarding the injection pump, it's been sitting plugged up and full of fuel for like 5yrs. I pulled the cover off the advance piston and didn't see anything like water or rust in there. will mount it on my rabbit and use a primer bulb to force some diesel purge thru it and try and start it. it should run, there's no obvious reason why it shouldn't, but this pump will most certainly need a reseal. I can do that but that would add 100 to the price. hope this helps any interested buyers.
-
#5
by
rabbid79
on 21 Mar, 2013 14:58
-
How much for the rods?
-
#6
by
ilikevwdiesel
on 21 Mar, 2013 15:07
-
someone is interested in the shortblock, so i can't part it like that right now. probably would hold onto it anyways cause the bores aren't that bad really.
-
#7
by
ilikevwdiesel
on 25 Mar, 2013 15:37
-
short block sold.
-
#8
by
rudygetz
on 28 Mar, 2013 10:02
-
Do you have an A/C compressor? Or the non-A/C bracket on the alternator?
I'm trying to convert my rabbit to non-A/C setup...do you have what I need to accomplish that?
-
#9
by
ilikevwdiesel
on 28 Mar, 2013 10:06
-
yes I do. pm sent
-
#10
by
shwak23
on 28 Mar, 2013 12:34
-
Do you have a glow plug bus bar and an oil cooler and all related hoses?
Sent from Outer Space!
-
#11
by
Luckypabst
on 30 Mar, 2013 21:48
-
Lower timing belt cover?
Chris
-
#12
by
8v-of-fury
on 30 Mar, 2013 22:07
-
How much for the pump good sir?
-
#13
by
ilikevwdiesel
on 31 Mar, 2013 03:17
-
the lower timing belt cover fell to bits when it was removed
not sure what I"m doing with the pump right now. mounted it on my na motor just to try it out but it's all gummed up inside, would only run when fuel was being forced thru it. looking for offers on it I guess. don't think there's any rust inside but maybe the head should be removed to see if there is any in there.