-
List of tools to R&R a 020 transmission?
by
erice1984
on 10 Aug, 2011 19:04
-
I am looking for a list of tools, and pictures of these tools so I can R&R a 020 transmission.
Thanks
-Eric
-
#1
by
theman53
on 10 Aug, 2011 19:15
-
-
#2
by
rallydiesel
on 10 Aug, 2011 20:19
-
A simple shop press (~12 ton) is a must.
-
#3
by
RadoTD
on 22 Sep, 2011 01:50
-
Define R&R... are you swapping transmissions or rebuilding one?
-
#4
by
nathan_b
on 22 Sep, 2011 12:00
-
R&R is pretty universal as remove and replace...
-
#5
by
R.O.R-2.0
on 22 Sep, 2011 12:11
-
it takes nothing more than simple hand tools to remove and replace a trans, but REBUILDING a trans, takes a press, and all that sorts of cool stuff..
-
#6
by
burn_your_money
on 22 Sep, 2011 16:12
-
You'll need a 8mm 12pt triple square to get the axles off, and a scissor jack to push the engine ahead far enough depending on platform. A1,2 or3 or B? Also a 30mm socket.
Other then that it should already be in your tool box.
-
#7
by
RadoTD
on 22 Sep, 2011 21:10
-
R&R is pretty universal as remove and replace...
Yeah... both of the replies above me implied pulling the trans apart.
30mm socket is not needed, you don't have to pull the axle out on that end.
17mm sockets, shallow and deep, wobble extension or u joint and extension for whatever size your 17mm socket is.
13mm socket
8mm triple square
spare jack
Uhh, I think that's it
-
#8
by
burn_your_money
on 25 Sep, 2011 10:57
-
You have to take the drivers side axle out don't you? At any rate, I like the extra room it gives you.
-
#9
by
RadoTD
on 25 Sep, 2011 12:30
-
Ok... I've never had to, that might make be easier though! I just avoid that 30mm nut as much as I can
-
#10
by
R.O.R-2.0
on 25 Sep, 2011 12:39
-
You have to take the drivers side axle out don't you? At any rate, I like the extra room it gives you.
Ok... I've never had to, that might make be easier though! I just avoid that 30mm nut as much as I can
i dont touch either. i drop the ball joint bolt, and swing the hub and axle out of the way..