-
MTDI idle vibration
by
Andrewb
on 08 May, 2010 11:25
-
I've had my LR 200tdi pump running in the van for a while now, its seems to be running well and making about the right amount of power. The problem is that it vibrates quite a lot at idle, so I was wondering if anyone here had an idea of what might be causing it. The pump is completely standard, still need to do the govenor mod.
Thanks
Andrew
-
#1
by
CdnVWJunkie
on 08 May, 2010 15:09
-
If you increase the RPMs a little with the accelerator pedal does the vibration go away or lessen?
-
#2
by
Andrewb
on 09 May, 2010 00:52
-
Yes, that stops it.
-
#3
by
neimis
on 09 May, 2010 21:54
-
Are your engine mounts good? A new passenger side mount transformed my car from vibrating and shaking to smooth and purring. I replaced all the others as well, just to be sure. (Until I got the old mount removed, I could not actually tell that it was bad)
-
#4
by
snakemaster
on 10 May, 2010 09:51
-
i would have a look at the engine mounts ,have you seen ones from a A4 /pasat there real soft , i dont no if you got the room to fit them , i cant rember which ones you have fitted is it landrover ones , what dose your van tick over at .
-
#5
by
Andrewb
on 10 May, 2010 10:58
-
Ye, I'm on Landrover mounts atm, which are pretty rock solid tbh. Looks like finding some softer ones is the place to start.
Still need to get a rev counter, so can't say exactly what my idle speed is.
Any ideas of where to get softer landrover style (round with studs both sides) mounts?
Thanks
Andrew
-
#6
by
snakemaster
on 13 May, 2010 15:29
-
i got a set for a capri/ cortina for my manta a when i put the diesel in her seem a good bit softer than LR , what you done with your gearbox mount ?
-
#7
by
Andrewb
on 17 May, 2010 13:25
-
Ye, just ordered those type of mounts actually.
I'm using the mount that came from the sierra with the type 9, which mounts to a craddle I made for the g/b