Author Topic: Anyone make an EGR block off plate? (Read 2478 times)

allsierra123 · « **on:** October 02, 2008, 04:10:12 pm »

Or is it something I will need to come up with?

jtanguay · « **Reply #1 on:** October 02, 2008, 04:17:27 pm »

you could check out kerma TDI.

it's not too hard to make though... just get a piece of steel and cut it then drill some holes, and bingo. you can use the egr line as a template even.

allsierra123 · « **Reply #2 on:** October 02, 2008, 04:25:01 pm »

Nice. Wastn sure if it had to be anything special or not.

blkboostedtruck · « **Reply #3 on:** October 02, 2008, 06:50:17 pm »

i might have one? i bought an intake that had one but i welded up the hole because i needed more clearance but i still have the plate left!
Duane

blunt · « **Reply #4 on:** October 05, 2008, 03:19:27 pm »

I used a bit of 5mm deep flat bar, cut it to match the shape of the flanges on the egr i removed, drilled it and bolted it straight on to place, piece of cake!

commuter boy · « **Reply #5 on:** October 05, 2008, 11:40:57 pm »

Piece of sheet metal for me. Cut it with some tin snips, filed the edges, drilled a pair of holes and in it went.

Author Topic: Anyone make an EGR block off plate? (Read 2478 times)

allsierra123

allsierra123