Author Topic: hybrid turbo? (Read 6644 times)

zaprzal · « **on:** May 02, 2007, 06:11:49 am »

I want to build hybrid turbo. Bigger impeller (k26) put into smaller, machined housing (k24). Is it good or bad idea? How does it work if I compare hybrid vs stock turbo?

RabbitJockey · « **Reply #1 on:** May 02, 2007, 06:39:54 am »

it can be done it's an upgrade... this turbo won't fit on like the stock one, you'll need a spacer for it to fit. i think when it was discussed before, that it was decided that an aftermarket turbo is a better route, but the k24/k26 hybrid is the cheaper route

zaprzal · « **Reply #2 on:** May 02, 2007, 08:09:32 am »

Quote

you'll need a spacer for it to fit.

what spacer and why?

another question is if this hybrid will be more efficient than stock turbo if I stick with stock small, machined housing?

RabbitJockey · « **Reply #3 on:** May 02, 2007, 09:29:46 am »

the compressor housing is bigger and won't fit, the spacer would go between the turbo and the manifold, from what i know. do a search this has been covered before

zaprzal · « **Reply #4 on:** May 02, 2007, 09:54:18 am »

I want to use stock k24 compressor housing only machined to fit on bigger impeller. What do you think about it?

jtanguay · « **Reply #5 on:** May 02, 2007, 10:57:12 am »

if you can do it... go for it! sounds to me like quite a bit of machining though... make sure you can get it nice and smooth in case the compressor wheel rubs a little bit... but ideally you don't want it to rub at all!

zaprzal · « **Reply #6 on:** May 10, 2007, 07:57:13 am »

one more question, should I put bigger cold side and stick with stock k24 hotside, or should I also put bigger k26 hotside?

Audi80 · « **Reply #7 on:** May 10, 2007, 11:27:02 am »

How big is that K26?

zaprzal · « **Reply #8 on:** May 10, 2007, 01:27:50 pm »

hard to tell. It's from iveco truck 2,8td, probably bigger than mercedes one but who knows

zaprzal · « **Reply #9 on:** May 10, 2007, 11:34:45 pm »

I'm afraid if stock k24 hotside would make too much exhaust gas pressure :?

zaprzal · « **Reply #10 on:** June 03, 2007, 10:20:32 am »

anybody will help? is it better to stick with stock k24 hotside or put something bigger?

Darkness_is_spreading · « **Reply #11 on:** June 04, 2007, 04:40:48 pm »

No machining required, you need a complete K26 and K24 turbo. Take off the compressor side of the K24 down to oil cooler, then replace with K26 components from that point on: ( flange, compressorwheel, and K24 nut and K26 housing)

Author Topic: hybrid turbo? (Read 6644 times)

Audi80