LDA pump fittings for running a MBC.. - IDI Engine - VWDiesel.net The IDI, TDI, and mTDI source.

• LDA pump fittings for running a MBC.. by bbob203 on 16 Jun, 2012 13:09
• If I were to get a few extra banjo fittings from an LDA pump top and put them onto my turbo and used them and some sort of tubing to hookup a MBC would it work? The diameter of the barb is small but it seems like it might work. The reason is I don't want to cut my hard line to install incase i ever want to take it off. With that said does any one have any extras of these they'd sell me?
• #1 by 745 turbogreasel on 16 Jun, 2012 16:26
• Are you trying to delay signal to the LDA?
• #2 by bbob203 on 16 Jun, 2012 16:49
• no the lda has nothing to do with it. I just wanted see if I used a couple of  the banjo barb fittings like the one that is on the pump, on the turbo in place of the hard line so I don't have to cut it up and a means to run a manual boost controller.
• #3 by 745 turbogreasel on 17 Jun, 2012 04:55
• I see where you are going, I had to run a bit bigger bore fittings than that  for my MBC to work like I wanted.
  I'd look for one with ~1/4" ID.
• #4 by bbob203 on 17 Jun, 2012 08:47
• Quote from: 745 turbogreasel on 17 Jun, 2012 04:55

  I see where you are going, I had to run a bit bigger bore fittings than that  for my MBC to work like I wanted.
  I'd look for one with ~1/4" ID.
  

  
  Ah ok thats exactly the answer i was looking for thanks! Where did you get the fittings?
• #5 by 745 turbogreasel on 17 Jun, 2012 15:53
• My wastegate came with rubber hose, and I cut it in the middle.