Any problems using a high grade flexible teflon hose for the turbo oil feed line? It would be a hell of a lot easier than solid tubing. Any experience? Any custom feed line pics are also appreciated
most other people use flexible lines
use teflon, an-stuff
37 degree flared is good
maybe a 90 off the filter housing to another 90
When doing any angle to angle the hoses will be ordered like this
13020204-xxxx-xxx
13 teflon ( titeflex) 1500 psi working
02=90
02=90
04=size -4
xxxx hose in inches and eight's of a inch
xxx=rotatation angle
One angles will be clocked at 000 rotation, the other end will be the rotation in degree's
You may purchase a adjustable angle fitting or just add a elbow on both mounting surfaces and you can use straight fitting's on the hoses assy
I had a aircraft hose shop for years..
teflon hose can be purchased with a clear shrink or firesleeve for protection
let me know if I can help ?
GB
That is what I did. Fittings are about 12.00 each and the hose is kinda pricey. I sold one for around 90.00 ready to bolt onto the car to a guy last month. IIRC JIC 6 hose and fittings. Turbo and filter flange are M12-1.5 to 6 JIC works like a champ.
I use braided high pressure line from the oil filter to the turbo. With AN adapters to pipe thread, works great for me.