...BTW your Bieber avatar is awesome.-Malone
I think he means the drive shaft bushings. They may be able to be tapped out but I doubt it. I think you will have to get them pressed out.
Hey Guys, The easiest way to change the bushings is to position the housing driveshaft seal up in the press and push both bushings out at the same time into the housing. The bore for the bushings does not have a raised section in the center. Make sure to use red loctight to install the new bushings. The align ream new bushings to 17mm driveshaft size. Hope this clears everything up for you guys. Glad to be of help Giles
Hey Guys,The easiest way to change the bushings is to position the housing driveshaft seal up in the press and push both bushings out at the same time into the housing. The bore for the bushings does not have a raised section in the center. Make sure to use red loctight to install the new bushings. The align ream new bushings to 17mm driveshaft size.Hope this clears everything up for you guys.Glad to be of helpGiles