Strip the motor right down to the crankshaft and drive it in with the starter. :twisted:
Probably not far enough, and I bet it would be a slow grind. I can just picture huge jams as it dies in the middle of a bridge. :lol:
yank the motor and drop a 1.6 NA in there
It's not like you would need to hook up the coolant system or any of the wires. I drove a NA rabbit for about a month with no rad LOL yeah it overheated and died
Well it did have a rad in it but it had a gaping hole in it. I'd fill it with water before leaving and usually about 15 minutes later it would start overheating. I'd keep driving until it was about in the red and then I'd just pull over on the side of the road for 5-10 minutes while it cooled down a bit :lol:
Quote from: "cyrus #1"Probably not far enough, and I bet it would be a slow grind. I can just picture huge jams as it dies in the middle of a bridge. :lol:get it towed to within a block... without any resistance from the crank, it should be able to get you there... :lol: