I bought this block with crank, and intermediate shaft, but only 3 rods and pistons. It is technically a new block but has been sitting under my bench for a while so it could use some cleaning and whatnot. When it was shipped to me before they put a small flat spot on the front of it and there is a scratch on the deck. It could all be fixed pretty easily. The important part here is that the bores are good which means a cheap and easy rebuild. Since I only have 3 of the pistons and rods I had plans on buying a set of used ALH pistons and rods. Polish up the crank and throw it together with new rings and bearings. Obviously none of that ever happened though and I ended up skipping over the AHU project and heading for the PD150. So, as a result I don't really have a use for this stuff and it isn't doing anyone any good under my bench.
Here are some pictures of what I have
Things have gotten a little crusty as you can see but I don't think it should really present a huge problem. I'm not sure what to ask so go ahead and send me a message if you're interested and we'll see if we can work something out. FYI, this is the block that bolts into a Rabbit.
Topic: FS: "NEW" AHU block, crank, etc. (Read 4266 times)
