Author Topic: pump timing metric/ASE conversion (Read 2814 times)

turbosuzi · « **on:** September 29, 2007, 09:20:00 am »

I bought a pump timing kit and rebuilt pump on ebay. Installed the pump and Im ready to time the pump but then I realized that the dial indicator is in inches. does anyone have the in metric conversions for the dial?

Also I was going to advance the timing but forgot what the amount of advence is.

jtanguay · « **Reply #1 on:** September 29, 2007, 10:09:58 am »

1 millimeter = 0.0393700787 inch

mk2diesel · « **Reply #2 on:** September 29, 2007, 02:19:08 pm »

depending on the engine .... .028" to .034" is in range aim for .032"

turbosuzi · « **Reply #3 on:** September 30, 2007, 10:39:20 am »

On the dial .032 would be at the 30 plus 2 ticks past. Correct?

mk2diesel · « **Reply #4 on:** September 30, 2007, 01:39:51 pm »

depends on the guage markings .. might only be 1 tick ( if 1 tick = 2 degrees)

turbosuzi · « **Reply #5 on:** September 30, 2007, 03:34:20 pm »

On my dial it reads 1 tick as .001 in.

jimfoo · « **Reply #6 on:** September 30, 2007, 08:22:48 pm »

You might want to go .04 as that is 1.01mm which is in the range most people advance their timing to.

Patrick · « **Reply #7 on:** October 01, 2007, 03:09:02 am »

Thy run well at .42...................

jtanguay · « **Reply #8 on:** October 01, 2007, 04:53:41 am »

iirc the lower timing is retarded for emissions. try for 0.039 or 0.040"

Author Topic: pump timing metric/ASE conversion (Read 2814 times)

turbosuzi

turbosuzi

turbosuzi