AAZ Crank timing mark? - IDI Engine - VWDiesel.net The IDI, TDI, and mTDI source.

• AAZ Crank timing mark? by goomicoo on 07 Jun, 2015 10:58
• I'm doing an AAZ swap into my Vanagon and would like to do the timing belt before I install the engine.
  The transmission is not mounted and there is no timing mark on the crank pulley that I know of.
  Is there one on the vibration dampener? I can't see any marks on the block to line one up with either 
  Is there a tool to use on the crank pulley to hold it @ TDC?
  Thanks for the help, I'm new to AAZ's 
  
  
• #1 by RunninWild on 07 Jun, 2015 21:55
• There should be one on the flywheel. If you haven't taken the belt off already just mark each sprockets location in relation to the block
• #2 by starrd on 13 Jun, 2015 22:31
• 
  
  tool can be found here: http://www.metalnerd.com/cat03.htm