So I've got a NA intake with the two half inch hose barbs, I've got an AAZ valve cover with the flat-ish oil sperator and an almost 1" nipple on it.
You can see the unsightly way it was plumbed with the huge brass fitting and a lot of hose clamps and a big wide bend of that 3/4 heater hose to the
oil separator. There has got to be a better way... Thoughts?
I am without my shop and boxes of spare hoses and fittings and junk I usually go to for cobbling stuff together unfortunately so I've got to buy something
or just use this junk till I get back to turbo land.
look into the 1Y PCV setup..
