so i did valve cover gasket as it was leaking alittle then i noticed still a few drops of oil on driveway so i looked like it was coming from oil pan gasket so i replaced that. then after all done and went out next moring and a flipping drip on drivway!!! WOW!!!!!
anwyas only thing i could think is it got alittle movment when lostening that bolt but it didnt move very much so now i dont want to take oil pan off again could i juist buy some of that high temp gasket sealer (copper stuff) and goop it around where it goes into the oil pan??? i would think this would work as there is no pressure just a drailage hole.....
grrrr.......
when i refer to it got alittle movment i mean the 90 pipe coming from the oil pan
If the actual 90 is loose then the weld has broken. Clean the outside of the pan and JB weld it up. Like you said, no pressure.