1.6td setup

[bryanb]

I know it is a T3 and a Giles pump but I don't know any specifics. What should it be capable of with the plans of a inter cooler. As of now it peeks at 11psi and runs 10. Are there adjustments and things I should know. 

[URL=http://s1223.photobucket.com/user/glass-frog/media/24d687798aa7b2637d805c7d7f791150_zps1bbe9c17.jpg.html]

[bryanb]

[Trips_B]

looks nice!

If you add an intercooler I would just add a manual boost controller and set it to 20psi
My 1.6 rebuilt with a T3 pulled hard at 20, with your giles pump it'll be even better

As well check your timing, Giles pumps are tuned to run at a certain spec.  perhaps getting in touch with him is your best option there

[GEE-BEE]

Get a Bell Intercooler

Callaway version/ 335.00

Iam working on the silcone tubing to connect all of the together


http://forums.vwvortex.com/showthread.php?6982107-WTB-Callaway-AC-equipped-intercooler

Here is a airflter assy if you get tired of that noise...
http://www.ebay.com/itm/390515779701?ssPageName=STRK:MEBOFFX:IT&_trksid=p3984.m1427.l2649#ht_2545wt_983

[bryanb]

Ok so I got a Godspeed intercooler all set up and have a voodoo II boost controller but not 100% how or where to install it. I think it is the rubber line in the third pic from original post. Here is a pick of the linter cooler I ordered a 2 inch piping setup but got 2.5 somehow so I just made it work.

[Rising]

I also just picked up a similar intercooler and I'm mounting in the same position on my mk1.. What'd you do for mounts if I may bug you? Also curious to see how this turns out?

[RustyCaddy]

Very nice work.

 

To 2nd Rising...please tell us more about fitting the intercooler

[TimpanogosSlim]

I also just picked up a similar intercooler and I'm mounting in the same position on my mk1.. What'd you do for mounts if I may bug you? Also curious to see how this turns out?

I'm curious too. These things seem to have two big round bosses top and bottom.

I think i may have to trim my core support to fit my IC in. And even then i worry that mounting might interfere with the hood release cable.

[bryanb]

Believe it or not it has 3 of the electric fan mount that run through a rubber piece the core then the rad then another rubber piece and a locking tab. Then when I put the brackets on the rad it pinched it just right and it dosnt move. I still want to add some sort of bracket to the welded bungs on the top or bottom of the core but haven't got that far yet.

[TimpanogosSlim]

ok, that sounds like something that will ultimately cause you to need a new radiator. GLWS.