« previous next »
Pages: 1 2 3 4 [5]

Author Topic: My 1.6 project,,  (Read 15649 times)

Reply #60November 18, 2012, 09:05:30 am

TUFFY

  • Junior
  • Offline
  • **
  • 104
Re: My 1.6 project,,
« Reply #60 on: November 18, 2012, 09:05:30 am »
Hi, I bought rings from Prothe on Ebay a while back before I seen all the stuff about how bad some of his stuff is. Should I put these rings in my pulling engine?

The first engine is going to basically be a low buck test engine to see if it will be competetive in the class. Not rebored or new pistons.

Tom
Logged
Reply #61November 18, 2012, 02:04:39 pm

TUFFY

  • Junior
  • Offline
  • **
  • 104
Re: My 1.6 project,,
« Reply #61 on: November 18, 2012, 02:04:39 pm »
Hello, This is my block, is it machined for squirters already?
Logged
Reply #62March 18, 2013, 04:28:37 pm

TUFFY

  • Junior
  • Offline
  • **
  • 104
Re: My 1.6 project,,
« Reply #62 on: March 18, 2013, 04:28:37 pm »
Here is my steel flywheel for my tractor,,,
Logged
Reply #63March 18, 2013, 04:29:18 pm

TUFFY

  • Junior
  • Offline
  • **
  • 104
Re: My 1.6 project,,
« Reply #63 on: March 18, 2013, 04:29:18 pm »
back view,,
Logged
Reply #64March 18, 2013, 06:30:45 pm

libbydiesel

  • Global Moderator
  • Veteran
  • Offline
  • ****
  • 3399
Re: My 1.6 project,,
« Reply #64 on: March 18, 2013, 06:30:45 pm »
Yup, that's machined for squirters.  I've seen that once before on a non-turbo block about 12 years ago.  Out of curiosity, what's the engine block code?
Logged
Reply #65March 20, 2013, 11:04:30 am

TUFFY

  • Junior
  • Offline
  • **
  • 104
Re: My 1.6 project,,
« Reply #65 on: March 20, 2013, 11:04:30 am »
Quote from: libbydiesel on March 18, 2013, 06:30:45 pm
Yup, that's machined for squirters.  I've seen that once before on a non-turbo block about 12 years ago.  Out of curiosity, what's the engine block code?

I don't know the numbers off hand. Next time I work on it I will get them.
Logged
Pages: 1 2 3 4 [5]
« previous next »