Author Topic: just want to check (Read 5118 times)

mufflerbearing · « **Reply #15 on:** April 24, 2008, 03:37:10 pm »

yep, all pieces were gathered from 2 na engines. the injection is all from my old motor that was running great and its all on this "known good" "80k mile" longblock...

-j

Quantum TD · « **Reply #16 on:** April 24, 2008, 07:30:47 pm »

Compression test time.

mufflerbearing · « **Reply #17 on:** April 25, 2008, 02:59:13 pm »

clearance on 2 of the intake valves is a little big... just out of spec, but that wont effect compression. ill change them, but not yet.

i got # 3 and 4 done but couldnt fit the adapter between the pump and #1 and 2 so ill have to figure something else out. looks like i might have an adapter for the injector that im gonna have to try out and see if it works.

so far i have about 540psi at 3 and just a hair under that in 4.

so, half of the motor is good, anyway...

-j

mufflerbearing · « **Reply #18 on:** April 28, 2008, 12:36:06 pm »

had a spare moment today so i checked the compression

im getting ~500psi across all 4 cylinders.

when i pulled the 2nd injector, its tip was covered in oil...

any ideas? valve stem seal?

-j

burn_your_money · « **Reply #19 on:** April 28, 2008, 06:27:05 pm »

try bumping the timing down to 0.90

Did you replace the heatsheilds after the compression tests?

mufflerbearing · « **Reply #20 on:** April 28, 2008, 08:32:42 pm »

ill try bumping the timing down a bit.

i have not been able to find my extra heat shields... know of a place online i can order a set or 2?

-j

theman53 · « **Reply #21 on:** April 29, 2008, 04:19:45 am »

here one place I know of they are pretty cheap too
http://www.autohausaz.com/index.html

mufflerbearing · « **Reply #22 on:** April 29, 2008, 09:36:50 am »

ordered a set.

also have valve stem seals on the way and the special tool to press them in without removing the valve/head.

we'll see how it all goes next chance i get to work on it

-j