Hey fellas,
I dyno'd my AAZ today...
thats at the wheels. I'm pretty happy.
Turbo - Merc T3
Pump - fuel screw turned up a little, 1.5mm shim on the main spring in the governor, 1.6TD pin
Injectors - stock
Front mount Inter-cooler
Stock internals
Stock inlet manifold
2.5" exhaust and downpipe, with resonator and rear muffler
video -
http://www.youtube.com/watch?v=DC1VeOgegac
Which one is the real torque? 225nm which plot shows or 189nm what it says
189... I dont know why the scale is wrong. I might go aske them for another plet with correct scale.
That's cool! Are you blowing any black smoke at all? How high does your EGT get on a run like that?
on the dyno run, there was some black smoke, but not much (see the video, but note that the wall behind the dyno is already stained with soot). I have since given it another 1/4 turn in on the fuel screw.
Last night I did a very long (3rd, then 4th gear) pull at full throttle. I happily noted the EGT didnt see over 620C, so thats pretty good. I imagine on the dyno it would have been similar or less.