-
Gasser 16 Valve stuff FS
by
dennis
on 20 Feb, 2010 06:21
-
This is for you closet gassers out there. I have a 2.0L 16 Valve block that was going into my Caddy before I got on the turbodiesel drug. It is bored 20 over and comes with custom Diamond Racing 8.5 to 1 pistons with Total Seal rings. It has not been assembled. A friend has the head and was supposed to port and polish it, but has not. The head goes with it. This thing has been apart for a few years. I have $500 in the pistons, and would like to get that for it, but will consider reasonable offers. Thanks
-
#1
by
Rabbit on Roids
on 20 Feb, 2010 07:56
-
wanna sell the oil pump, pump drive, intermediate shaft w/ sprocket and crank sprocket?
im building a supercharged ABF and need those pieces..
-
#2
by
catlin_cava
on 20 Feb, 2010 09:19
-
I'm interested in the complete Head assembly.
-
#3
by
dennis
on 20 Feb, 2010 10:04
-
Let me put my hands back on it, and I will PM you.
-
#4
by
Rabbit on Roids
on 23 Feb, 2010 09:07
-
any word on the engine?
-
#5
by
dennis
on 23 Feb, 2010 10:46
-
any word on the engine?
I would rather sell the block with the intermediate shaft in it. Cant seem to find the oil pump drive gear. I can sell you a new Schadek oil pump for $70.00 + ship though.
-
#6
by
Rabbit on Roids
on 23 Feb, 2010 11:07
-
no thanks, cause the intermediate shaft is the most important part i need right now. and i dont want a 9a block, cause im doing all this work to an ABA so i can have a low compression, easy breathing engine, instead of a high compression 9a
as for the oil pump, if you had the drive gear and block hole filler, i would be up for it, but if its just the oil pump, no thanks.
-
#7
by
Turbinepowered
on 23 Feb, 2010 13:36
-
Can you put a 16v head on a mechanical lifter gasser block?
-
#8
by
Rabbit on Roids
on 25 Feb, 2010 18:18
-
as long as it has the oil pressure feed for the lifters.
-
#9
by
dennis
on 26 Feb, 2010 05:53
-
Valve relief in the piston tops may alsom be a concern.
-
#10
by
Rabbit on Roids
on 27 Feb, 2010 11:28
-
Valve relief in the piston tops may alsom be a concern.
i didnt have to notch the pistons on my 16vABA. used the stock ABA pistons and a 9a head, with a aba steel head gasket.
so, if the pistons protrude, you will need them notched, but on an ABA, because of the taller deck height, the pistons sit down in the bores quite a ways even at TDC.
interested in parting that engine out yet?