i like the idea of using plastic. its so much easier to get that molded up than using aluminum, and it has a high tolerance to heat soak. and to those who might put down plastic because they think its weak... well theres bullet proof plastic, which is still lighter than steel but wayyy stronger. molds aren't too expensive, and maybe if enough of these intakes were made they could sell for pretty cheap... but there is still the aluminum pieces that need to be made.. which is a bit depressing
i wonder how it would last if the plastic runners were bolted right to the head? there would need to be some heat shields for sure from the exhaust manifold seeing how close they are. i'm going to go check if the aluminum pieces of this can be bought separately... and for how much.
edit: this would work well for someone with the bolt on turbo upgrade (converts the n/a pump to turbo via the max fuel screw.. but forget the company's name)
or someone could just buy mine woot woot
