Well, I swapped out the IP with another used one, and what do you know, it actually runs! Smoking white smoke, not too much (when idling the air is clear about 3 feet from the exhaust), but enough to let it clear before I open the door to the house. It seems like it has a problem sucking enough fuel. though - it won't really rev until I squeeze the primer bulb, and then it's a rough revving. I'm going to get the pump timed tommorrow. Then it's on to fixing the electrical stuff - light bulbs, etc.
Oh, almost forgot - it's leaking oil out of where the dipstic enter the block. Any ideas?
Glad to hear that you got it running. There is an O-ring between the block and the dipstick tube that may need to be replaced. Good luck
Nick
It seems like it has a problem sucking enough fuel. though - it won't really rev until I squeeze the primer bulb, and then it's a rough revving.
look for leaks in the feed line. I bet there are a few. It won't run properly if it's sucking air anywhere.
I suspected that, although I can't see air bubbles anywhere; although it could be the shaft seal on the pump. I'm going to try and free up the old pump to see if A) I can figure out how it works, and B) get it working w/the right seals for when I goi bio. Or, I'll make some artwork out of it...
I suspected that, although I can't see air bubbles anywhere; although it could be the shaft seal on the pump. I'm going to try and free up the old pump to see if A) I can figure out how it works, and B) get it working w/the right seals for when I goi bio. Or, I'll make some artwork out of it...
artwork, definately. I'm still planning my bio conversion for the jetta, but i have to come up with a way of heating the injector lines (metal ones) because the veggie oil sits in there for a long time before it is injected and cools down.