Need Good 1.9td IP - IDI Engine - VWDiesel.net The IDI, TDI, and mTDI source.

• Need Good 1.9td IP by Chuck on 05 Apr, 2005 14:32
• HI  just got my engine in ( samurai)  but the IP{ leaks - well leak is to wimpy a term)  from the throtle shaft  so...
  
  anyone have a 1.9 turbo pump for sale?
  
  Thanks
  
  Chuck
• #1 by vwmike on 05 Apr, 2005 15:08
• Maybe you could just replace the bushing on the throttle shaft? 068 130 718 is the part number I beleive.
• #2 by Smog on 05 Apr, 2005 15:55
• Quote from: "Chuck"

  HI  just got my engine in ( samurai)  but the IP{ leaks - well leak is to wimpy a term)  from the throtle shaft  so...
  
  anyone have a 1.9 turbo pump for sale?
  
  Thanks
  
  Chuck

  
  
  any diesel injection specialist in your area can change the seal (and mod the governor at the same time)
• #3 by fspGTD on 06 Apr, 2005 10:03
• That's a simple O-ring.  You've got to remove the governor "lid" to get at it though, remove the throttle cable to shaft linkage at the top, and then pull the throttle lever down through the bottom to get at the throttle shaft o-ring.  Get a VE pump rebuild kit, they are cheap like under $20 and include all the crush washers, gaskets and o-rings for the pump.
  
  Here you can see in this kit the throttle o-ring is number 4:
  
  
  There is also a brass bushing.  Those are not included with the VE pump rebuild kit, and would need to be pressed in and out.  But if the throttle shaft doesn't have "play", just a leak, I'd try just replacing the o-ring.
• #4 by steve on 07 Apr, 2005 09:21
• I replaced that o-ring in mine and it worked fine.  It wasn't too hard to get apart but just took some careful observation of where things went and how it came apart.  I pressure washed the engine compartment prior to surgery and kept everything very clean in the process.