VWDiesel.net The IDI, TDI, and mTDI source.

General Information => Troubleshooting => Topic started by: ffgb on December 14, 2009, 11:49:20 am

Title: Injection Pump Pulley!
Post by: ffgb on December 14, 2009, 11:49:20 am

How do you guys loosen and tighten the Injection Pump Pulley?  What tools do you use if you do not have that fancy long bar tool to add resistance in the opposite direction of travel when loosen/tighten Injection Pump Pulley bolt?
Thanks

Title: Re: Injection Pump Pulley!
Post by: truckinwagen on December 14, 2009, 11:54:02 am

you can put a screwdriver through one of the holes in the pulley into the hole in the bracket behind it

Title: Re: Injection Pump Pulley!
Post by: Rabbit on Roids on December 14, 2009, 05:06:39 pm

leave the belt on it, then loosen the nut. then pull the sprocket off. done.

Title: Re: Injection Pump Pulley!
Post by: Op-Ivy on December 15, 2009, 10:03:03 am

Quote from: truckinwagen on December 14, 2009, 11:54:02 am

you can put a screwdriver through one of the holes in the pulley into the hole in the bracket behind it

This works well too if you use a deep socket. Can't remember the size but if you try a few you can get one that locks the pulley completely. The vw tool is a cylinder of some sort that fits into the pulley hole, then hole behind it.