« previous next »
Pages: [1]

Author Topic: Injection Pump Pulley!  (Read 4299 times)

December 14, 2009, 11:49:20 am

ffgb

  • Junior
  • Offline
  • **
  • 244
Injection Pump Pulley!
« on: December 14, 2009, 11:49:20 am »
How do you guys loosen and tighten the Injection Pump Pulley?  What tools do you use if you do not have that fancy long bar tool to add resistance in the opposite direction of travel when loosen/tighten Injection Pump Pulley bolt?
Thanks
Logged
Reply #1December 14, 2009, 11:54:02 am

truckinwagen

  • Veteran
  • Offline
  • ***
  • 1895
Re: Injection Pump Pulley!
« Reply #1 on: December 14, 2009, 11:54:02 am »
you can put a screwdriver through one of the holes in the pulley into the hole in the bracket behind it
Logged
83 Opel Kadett Diesel
Reply #2December 14, 2009, 05:06:39 pm

Rabbit on Roids

  • Guest
Re: Injection Pump Pulley!
« Reply #2 on: December 14, 2009, 05:06:39 pm »
leave the belt on it, then loosen the nut. then pull the sprocket off. done.
Logged
Reply #3December 15, 2009, 10:03:03 am

Op-Ivy

  • Veteran
  • Offline
  • ***
  • 513
Re: Injection Pump Pulley!
« Reply #3 on: December 15, 2009, 10:03:03 am »
Quote from: truckinwagen on December 14, 2009, 11:54:02 am
you can put a screwdriver through one of the holes in the pulley into the hole in the bracket behind it

This works well too if you use a deep socket. Can't remember the size but if you try a few you can get one that locks the pulley completely. The vw tool is a cylinder of some sort that fits into the pulley hole, then hole behind it.
Logged
Pages: [1]
« previous next »