Author Topic: 1.6/1.9 IDI Engine Dimensions (Read 3253 times)

TemporarilyOffline · « **on:** August 01, 2007, 08:37:52 am »

Can anybody give me some measurements on the 1.6/1.9IDI engine height, width, depth?

I'm looking to fit an IDI into my car and need to know if its possible.

- Steve

Vincent Waldon · « **Reply #1 on:** December 24, 2008, 12:26:57 pm »

Christmas bump.... anyone got an engine out at the moment and can measure the approximate locations of the mounts, size of the hole, etc ?

Swapping *in* a diesel is a worthy Christmas cause !!

madmedix · « **Reply #2 on:** December 24, 2008, 12:32:32 pm »

As a matter of fact, I have a 1.6TD sitting on an engine stand right now....in the back shed...over 100 ft away and the snow is just over 3 ft deep. However, it just started raining and we'll see...

cyrus #1 · « **Reply #3 on:** December 24, 2008, 01:12:40 pm »

I'm heading out right now but should be able to nab some dimensions off of my 1.6 later today.

burn_your_money · « **Reply #4 on:** December 24, 2008, 01:34:37 pm »

I happen to have a 1.6 and a 1.9 sitting in the shop behind me. I'll be back in 5 with some numbers

roughly, 24" high, 24" wide and 20" long. That's without the turbo, which would be about another 3" wide

The 1.9 is about an inch taller

MJF · « **Reply #5 on:** December 24, 2008, 01:37:37 pm »

http://www.haywood-sullivan.com/vanagon/TDI/tdi_engine_cad_drawing_small.pdf

1,6 block is 16mm lower IIRC

Vincent Waldon · « **Reply #6 on:** December 24, 2008, 02:17:45 pm »

Thanks all.. the OP emailed me and I knew I could count on youse guys... sniff!!!! :cry: :lol:

Vincent Waldon · « **Reply #7 on:** December 24, 2008, 02:26:09 pm »

Quote from: "MJF"

http://www.haywood-sullivan.com/vanagon/TDI/tdi_engine_cad_drawing_small.pdf

1,6 block is 16mm lower IIRC

Very cool, btw... bookmarked with thanks !!