-
Oil fliter thread size
by
foxracer1
on 15 Feb, 2007 23:24
-
So i plan on installing an air to oil cooler. And i would still like to have the water to oil cooler/heater so it still warms up quickly. But i'm unsure of the thread size so that i can purchase a spin on adapter. I plan on installing a remote mount oil filter too because the filter is already close to the radiator as it is. I also plan on installing a thermostat so the air to oil cooler only circulates all the oil above 180.
-
#1
by
burn_your_money
on 16 Feb, 2007 07:36
-
I'm also thinking about a remote mount oil filter, it would make life so much easier
-
#2
by
carrizog60
on 16 Feb, 2007 08:18
-
i have both oil coolers mounted.
a adapter plate under the stock cooler and the filter.
only issue was that i have to find a oil filter that was half the height of the stock one...
problem solved and now the oil warms quickly and maintains the temp. more steady
-
#3
by
jimfoo
on 16 Feb, 2007 08:22
-
I believe it is the same size as a Ford FL1a filter. The oil cooler adapter I have has a built in thermostat. I didn't have the clearance for the stock cooler in the stock location in my application(Rover), but I put it in up by the remote filter in case I ever want to try pumping water through it for a hot shower while camping.
-
#4
by
foxracer1
on 16 Feb, 2007 09:42
-
So which adapter did you buy, I know its metric but im not sure which.
-
#5
by
carrizog60
on 16 Feb, 2007 13:18
-
i have a mocal with thermostat
-
#6
by
foxracer1
on 16 Feb, 2007 16:02
-
I'm sorry to be this picky but do you have the P/N or the thread size?
-
#7
by
carrizog60
on 16 Feb, 2007 16:25
-
don't know what you mean... :oops:
tomorrow i will take a pic of my setup :wink:
-
#8
by
Baxter
on 16 Feb, 2007 16:54
-
3/4 UNF.
-
#9
by
scopefrfd
on 17 Feb, 2007 17:48
-
I believe it's 3/4 x 16