Author Topic: MTDI Mechanical VNT Control  (Read 3005 times)

November 24, 2022, 03:35:22 pm


  • Newbie

  • Offline
  • *

  • 1
MTDI Mechanical VNT Control
« on: November 24, 2022, 03:35:22 pm »
Hey all,

New to the forum, but have trolled for a while. I have two Ď80 rabbit pickups. One currently has an MTDI 1Z with a Giles customized LR 300 pump and I just picked up an ALH for the other one and plan on sending out some cores to Giles for another pump.

I remembered seeing some posts about mtdi VNT control, but I havenít had any luck turning up anything of real value... is there a write up anywhere for a mechanical setup? All I could find were a few pictures from Rock3tman and nothing is that recent. Is this concept dead?


Reply #1November 24, 2022, 10:42:35 pm


  • Veteran

  • Offline
  • ***

  • 2734
Re: MTDI Mechanical VNT Control
« Reply #1 on: November 24, 2022, 10:42:35 pm »
  I haven't done a writeup on my VNT-15 controls using levers and rods.
 But we had a discussion on the vortex.
 Nathan Brame over on utube has some videos on how he did his controller.
You'd have to search his videos for it:

Here's his name on the vortex:
searching his posts will show the discussion of his and my controllers.
« Last Edit: November 24, 2022, 10:48:32 pm by fatmobile »
Tornado red, '91 Golf 4 door,
with a re-ringed, '84 quantum, turbo diesel, MD block