Author Topic: NTB: 12mm 3 notch IDI head (Read 5719 times)

jhax · « **on:** June 27, 2022, 05:24:45 am »

Good Day All,

I am in need of a solid lifer 1.6d head made after 83. This is a need for my business vehicle so time is of the essence.

Thank you,
Justin

[email protected]

fatmobile · « **Reply #1 on:** June 27, 2022, 10:30:19 pm »

Where are you located?

jhax · « **Reply #2 on:** June 28, 2022, 06:10:10 am »

Colorado, although I may have already found one, what are the details of yours?

Thank you,
Justin

fatmobile · « **Reply #3 on:** June 29, 2022, 09:00:27 am »

I have a couple used 12mm heads, not sure what I would sell them for.
But I don't need them all and have been thinking about selling one.

libbydiesel · « **Reply #4 on:** June 29, 2022, 04:09:43 pm »

The thread title confuses me. The notches are in the head gasket. The head gasket (number of notches) is determined by the protrusion of the pistons above the block at TDC. The head doesn't enter into the equation.

jhax · « **Reply #5 on:** June 29, 2022, 07:53:02 pm »

My apologies, Libby you are correct, I am in need of just a 12mm mechanical head.

I edited the title for you so it reflects that you need just the head. ORCoaster

Author Topic: NTB: 12mm 3 notch IDI head (Read 5719 times)

jhax

NTB: 12mm 3 notch IDI head

fatmobile

Re: NTB: 12mm 3 notch IDI head

jhax

Re: NTB: 12mm 3 notch IDI head

fatmobile

Re: NTB: 12mm 3 notch IDI head

libbydiesel

Re: NTB: 12mm 3 notch IDI head

jhax

Re: NTB: 12mm IDI head