hmmm thats not what i'd expect... if you spliced into the thermoswitch lines then you should only get one light come up for low and one for high.
hmmm thats not what i'd expect... if you spliced into the thermoswitch lines then you should only get one light come up for low and one for high.
led's are great. one way electricity travel, splice them to your ground source, and yes they take very little power to light up. hmmm does seem like a lot of wiring to get it on the dash though...
I spliced into the fan wires at the fan to bypass the fuse side. I have blown a fuse before and thought the fan was on. I used a lightweight speaker wire and ran it back to the dash and drilled a couple of holes in a blank on the dash. The switch is next to the leds. I didn't realize it would feed out of the low speed into the high speed wire.