I recently installed a new driverside e-break cable, it went smoothly andI put in a new cotter pin and fastened her all up, I go to test the breaks and notice a rubbing noise comming from the back drums.
The noise goes away after a stop breaking, and after they are heated up.
Are my drums out of round or do I need to adjust the breaks.
So the noise comes and goes? I'd recommend taking it apart again and looking for whats rubbing. shoe hold down spring/retainer comes to mind.
If the noise was a one time thing after re-assembly, it may have just been some crud in the drum. Like a bit of rust from the drum ridge.
Drums out of round would result in pulsating pedal and a jerky rolling motion at slow speed when you pull on the e-brake.
Most common signs of rear brakes needing adjustment would be low brake pedal or high parking brake travel. A2 auto-adjusters seem to be pretty good