Okej so this is my problem:
After I got the bearings replaced and the intermediate shaft installed I turned the shaft over by hand and it dident move easy. With a 19mm wrench I can turn it around but it feels like I have to use to much force for it to work properly when the engine is installed again.
The bearing was not installed by a professional and when I put the shaft back in i had to hit it a little with a rubber hammer.
Both bearing was oiled when I inserted the shaft.
Is the bearings not strait? Do they have to wear in? Will the belt even turn the shaft around?
Crank and everything is out untill some of you guys can get me some good answers