« previous next »
Pages: [1]

Author Topic: WTB early 1.6 crank sprocket with non-integrated key  (Read 6129 times)

September 27, 2013, 09:02:06 am

Dakotakid

  • Veteran
  • Offline
  • ***
  • 1240
WTB early 1.6 crank sprocket with non-integrated key
« on: September 27, 2013, 09:02:06 am »
I am currently working on a "CR" code ('82 Jetta) engine and am in need of a good non-integrated front (where else?) crankshaft sprocket.

These fit the earlier crankshaft which has the narrow keyway and actually utilizes a key which is seperate from the sprocket.

I actually even forgot these exist as everything I run utilizes the newer integrated sprocket and key.

I may have one in my storage mess and will start looking for it later today. But THAT is a herculean task at the slightest.....right up there with waterboarding. So if you have a non-damaged one......let's talk.
Logged
The mask and the shot(s) are actually an IQ test. If you are wearing or circulating, you just failed the test. I can't feel sorry for you.
Reply #1September 27, 2013, 12:46:18 pm

CRSMP5

  • Guest
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #1 on: September 27, 2013, 12:46:18 pm »
jetmug speed tester guy found one over a yearago.. id pm him with a where did you find it.. :P

same as old 1.5 fyi...  theman asked me abt same sprocket yesterday... also as a  special washer too...
« Last Edit: September 27, 2013, 12:49:23 pm by CRSMP5 »
Logged
Reply #2September 27, 2013, 06:49:34 pm

Dakotakid

  • Veteran
  • Offline
  • ***
  • 1240
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #2 on: September 27, 2013, 06:49:34 pm »
Yes, and thanks. I crawled through over 50% of my crap today and did not come up with one.

Still looking and please PM me if you have one.
Logged
The mask and the shot(s) are actually an IQ test. If you are wearing or circulating, you just failed the test. I can't feel sorry for you.
Reply #3September 27, 2013, 07:22:54 pm

CRSMP5

  • Guest
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #3 on: September 27, 2013, 07:22:54 pm »
ohh i has.. but i also has the crank and long block it goes on.. :P so not for sale.. running engine...
Logged
Reply #4September 27, 2013, 07:54:07 pm

Dakotakid

  • Veteran
  • Offline
  • ***
  • 1240
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #4 on: September 27, 2013, 07:54:07 pm »
Right.
I'm starting to think I never had one of these on hand. You see....that was the deal with my original 1.5. That engine just ran and ran and ran....never needed any work. Then, the ex-wife ran it into a concrete block retaining wall one bright sunny morning.

Women......

That was about the time being single didn't look so bad........
Logged
The mask and the shot(s) are actually an IQ test. If you are wearing or circulating, you just failed the test. I can't feel sorry for you.
Reply #5September 27, 2013, 08:40:45 pm

libbydiesel

  • Global Moderator
  • Veteran
  • Offline
  • ****
  • 3399
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #5 on: September 27, 2013, 08:40:45 pm »
I know I have at least two of them, maybe three, but the question is where?  I'll keep an eye out.
Logged
Reply #6September 27, 2013, 11:12:41 pm

Dakotakid

  • Veteran
  • Offline
  • ***
  • 1240
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #6 on: September 27, 2013, 11:12:41 pm »
When all else fails.....check ebay.
Bryan in Purcell, OK had one. Dun bought it.
Logged
The mask and the shot(s) are actually an IQ test. If you are wearing or circulating, you just failed the test. I can't feel sorry for you.
Reply #7September 28, 2013, 10:10:08 pm

fatmobile

  • Veteran
  • Offline
  • ***
  • 2926
    • http://www.geocities.com/vwfatmobile/
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #7 on: September 28, 2013, 10:10:08 pm »
I have a couple extras.
 Just gave one to my buddy so I even know where they are.
PM me and we'll figure out payment.
Logged
Tornado red, '91 Golf 4 door, with M-TDI 12mm pump, south bend clutch, VNT-15 turbo, 02A trany
MK4s: 2000 TDI jetta, 2003 TDI wagon, 2000 golf 2.0 gasser.
'84 Rabbit with 1.7TD KY block pistons bored to 80mm, VNT-15
'84 GTI with stock 1.6TD starion intercooler.
Reply #8September 29, 2013, 10:37:58 am

Toby

  • Veteran
  • Offline
  • ***
  • 728
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #8 on: September 29, 2013, 10:37:58 am »
I am sure that I have some. I will look today.
Logged
Reply #9September 29, 2013, 12:49:29 pm

Rabbit79

  • Junior
  • Offline
  • **
  • 196
  • Personal Text
    Burns, Oregon,USA
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #9 on: September 29, 2013, 12:49:29 pm »
I believe these are the ones you're looking for if you want to go new. This is the only place I've found that still has them.

http://www.busdepot.com/049105263b
Logged
Current: 1979 Rabbit 4dr
            1984 F-250
            1999 Ford Ranger
Other v-dubs I've owned:
84 Rabbit
78 Rabbit (gasoline) flipped it end over end after driving all night and falling asleep at the wheel. RIP, it was a good little car.
70 Bug
Reply #10September 29, 2013, 10:09:39 pm

Dakotakid

  • Veteran
  • Offline
  • ***
  • 1240
Re: WTB early 1.6 crank sprocket with non-integrated key
« Reply #10 on: September 29, 2013, 10:09:39 pm »
The one from ebay should be here in few days. Hopefully, it is a good one.
If not, will contact one of the above. Thanks.
Logged
The mask and the shot(s) are actually an IQ test. If you are wearing or circulating, you just failed the test. I can't feel sorry for you.
Pages: [1]
« previous next »