I need a couple setups for the mk1 chasis for turbo diesel 1.6. Not sure exactly all parts needed as I have never seen one.
Will this box fit the mk2 intake rubber hose?
I think the mk1 TD air box had an oblong/oval shaped outlet where it connects with the hose. On the mk2 it's round.
But a MK2 airbox will fit a MK1.
mk2 fits but poorly and not very secure.
You can combine the tops to the bottoms of the mk1 and mk2...for instance an MK1 bottom and MK2 top.
I never see these suckers at local junkyards. I have mk2 stock setups but had cut the fenders out of 2 cars so that the little snap on piece could be fed through the other side and kind of hold things together and not push it into the vbelt, etc.
I almost blew my engine up a few months ago during a flash rain that came out nowhere and it started sucking it up on a short drive and left the box flooded with water past the filter.
Was hoping I could jamb the mk1 box onto the rest of my stock mk2 setup.
I guess I could block that side and open some kind of inlet on the other side and shove it somewhere but I hate to cut it up.
mk1 lower sounds like my best bet?