I think I'm going to start by checking out the EGR valve and going from there. The other thing to note is it passed emissions fine not too long ago so it isn't running rich and it doesn't have high NOx levels, but excessive EGR "air" would cause lean running without NOx which the emissions test wouldn't care about.
Could be the O2 sensor, clogged cat. Last time pluggs were changed? How do these time themselves? Can it be changed by the user? I have a 2.0 that was given to me that I'm going to sell, it seems the timing could be off even if there is a crank positioning sensor. I've not looked in the book yet to check it out... A good tuneup, followed with checking the cat and a new O2 sensor. If it is still getting that bad after all of that a compression check maybe? Maybe a bad, but still running MAP/intake sensor?
Quote from: nwcali6 on January 15, 2013, 07:26:59 amCould be the O2 sensor, clogged cat. Last time pluggs were changed? How do these time themselves? Can it be changed by the user? I have a 2.0 that was given to me that I'm going to sell, it seems the timing could be off even if there is a crank positioning sensor. I've not looked in the book yet to check it out... A good tuneup, followed with checking the cat and a new O2 sensor. If it is still getting that bad after all of that a compression check maybe? Maybe a bad, but still running MAP/intake sensor? being that these cars (1.8 digifant, 1.8 TBI, and 2.0) all have computer controlled timing.. the timing is supposed to be set to 0*.. But it still has a physical position that can be changed and the computer can only compensate so much? I'd imagine it would (should) put up a CEL if its off too much.. =if the timing is not right, the computer just compensates it.. so, even if you adjust the timing, the ECU will just compensate, and bring it back to where it wants it..moral of this story, dont adjust the timing, it just pisses the engine off..i would try looking at the cat, hollow it out, and try again..