LDA pump fittings for running a MBC..

[bbob203]

If I were to get a few extra banjo fittings from an LDA pump top and put them onto my turbo and used them and some sort of tubing to hookup a MBC would it work? The diameter of the barb is small but it seems like it might work. The reason is I don't want to cut my hard line to install incase i ever want to take it off. With that said does any one have any extras of these they'd sell me?

[745 turbogreasel]

Are you trying to delay signal to the LDA?

[bbob203]

no the lda has nothing to do with it. I just wanted see if I used a couple of  the banjo barb fittings like the one that is on the pump, on the turbo in place of the hard line so I don't have to cut it up and a means to run a manual boost controller.

[745 turbogreasel]

I see where you are going, I had to run a bit bigger bore fittings than that  for my MBC to work like I wanted.
I'd look for one with ~1/4" ID.

[bbob203]

I see where you are going, I had to run a bit bigger bore fittings than that  for my MBC to work like I wanted.
I'd look for one with ~1/4" ID.

Ah ok thats exactly the answer i was looking for thanks! Where did you get the fittings?

[745 turbogreasel]

My wastegate came with rubber hose, and I cut it in the middle.