Mandrel bender
Well I have a 3" downpipe. I figured I may as well go 3" all the way back. I mean money grows on trees right? And yes obviously stainless is more difficult to weld. I have the resources to have it done. 3" over the axle should fit fine. Lots of examples on the vortex. Some even with 4" turbo back vrt's. Supposedly the over the axle part is a pretty complex 3d Part. I will probably just run it out the side because I am lazy but I think that will be way too loud. Would it cause much back pressure to have the exhaust. Shrink down to say a 2.25 mandrel bend over the exhaust?Sent from my DROID X2
Unless ur making stupid power that tectonics should be plenty
Quote from: bgbmxer on February 16, 2012, 10:35:27 pmUnless ur making stupid power that tectonics should be plentyI have a stock 1.6td. I am pretty sure i need the full 3inch exhaust. lolOh and i have a 1990 GOLF.