« previous next »
Pages: 1 [2]

Author Topic: Bearings on crank too big? Crank hard to turn by hand  (Read 5219 times)

Reply #15January 11, 2011, 01:30:53 pm

Dakotakid

  • Veteran
  • Offline
  • ***
  • 1240
Re: Bearings on crank too big? Crank hard to turn by hand
« Reply #15 on: January 11, 2011, 01:30:53 pm »
Just out of curiosity: how did you store this crank while it was out of the engine? As in: lying on it's side or on end or hanging with wire or how??? Just wondering....that is all.
Logged
The mask and the shot(s) are actually an IQ test. If you are wearing or circulating, you just failed the test. I can't feel sorry for you.
Reply #16January 11, 2011, 02:46:40 pm

kevinm

  • Junior
  • Offline
  • **
  • 78
Re: Bearings on crank too big? Crank hard to turn by hand
« Reply #16 on: January 11, 2011, 02:46:40 pm »
standing up and down
Logged
Reply #17January 25, 2011, 09:05:57 pm

goon

  • User+
  • Offline
  • *
  • 35
Re: Bearings on crank too big? Crank hard to turn by hand
« Reply #17 on: January 25, 2011, 09:05:57 pm »
do you have a dial gauge? i would set the crank up with a dial gauge and rotate slowly to check the straightness... as said before is sounds like a warpage or bent crank.. (altho odd if you stored vertically) i've only know cranks to bend laying down..
Logged
Pages: 1 [2]
« previous next »