WTB: IP bracket

[sdwarf36]

I'm putting a '84 CY motor into my 91 Jetta. The IP bracket on the CY motor has a engine mount on it--the car doesn't. I'd like to keep the outgoing motor complete (and get the ingoing motor as close as I can to ready to install. )
 Anyone have one?

[lovinthedeez]

if you're talking about the mk1 motor mount, just cut it off like I did.

 
and this was going into a mk2.  just cut it off, you'll be fine.

[maxfax]

And, If you don't want to cut I'll trade you brackets....   I think I have the proper MK2 timing covers too....

[sdwarf36]

And, If you don't want to cut I'll trade you brackets....   I think I have the proper MK2 timing covers too....

Okie dokie-sounds good to me-You tell me what i need-I'll send you the coresponding mk1 stuff-Tell me what I own you( don't forget to to deduct for the hubcap clips!  )

[maxfax]

I'm putting an '85 ME in my '81 Rabbit so I got all kinds of stuff laying around here..   They only thing I don't have laying free is an MK1 IP bracket..  The one's I have are still on engines, in cars..   

I found the bracket, and timing covers..   The plastic covers I have are not spectacular, the upper cover has a piece broken out of it....   Here's some pics..

http://s295.photobucket.com/albums/mm124/maxfax3/VW/ip%20timing/

[sdwarf36]

Looks good enuff for me. The cover wont slow the build up. I dont think i still have you address -email it to me [email protected] 
 The metal outer cover I have isn't mint either-had a dent in it from an accident.
LMK what you want to do.