Pump Install Question??

[ein bora]

Well I have everything installed and I'm ready to try and start the motor. I had my pump rebuilt by Giles, injectors rebuilt, new timing belt and tensioner. Everything's lined up to tdc. Is there any thing I need to do to the pump like prime it before I try and start? The pump timing's reset to where I had marked it for initial start up as I don't have a gauge as of yet.
Any help appreciated. Thanks.

[dash cunning]

you can blow some air into the return and prime it like that. also you can take off the return banjo from the pump and fill it up. i would set the timing first before you start it tho.

[burn_your_money]

Turn the engine over by hand to make sure that no valves are kissing the pistons.

You are probably going to have a hard time priming it just by cranking. Make sure to have the battery on a charger if you are doing that.