« previous next »
Pages: [1]

Author Topic: Pump Triangle Socket  (Read 3725 times)

December 17, 2009, 02:01:15 am

ffgb

  • Junior
  • Offline
  • **
  • 244
Pump Triangle Socket
« on: December 17, 2009, 02:01:15 am »
I am looking for the special pump triangle socket so I can disassemble my IP.  I have found one at on the MetalNerd website and the KermiTDI website for about $24.  Will this one work with my stock VE 84 Rabbit IP?  I just didn't know if there were different size triangle bolts because the MetalNerd tool is used on a TDI pump, not a NA pump?
Thank You
Logged


Reply #1December 17, 2009, 04:49:50 am

745 turbogreasel

  • Guest
Re: Pump Triangle Socket
« Reply #1 on: December 17, 2009, 04:49:50 am »
I ground 3 flats off a 1/2" 6pt, and it worked great.
I tried a super cheap one(you know the 40 tools for 5 bucks set) first, and it was not up to it.
Logged
Reply #2December 17, 2009, 08:13:58 am

anto

  • Guest
Re: Pump Triangle Socket
« Reply #2 on: December 17, 2009, 08:13:58 am »
I took mine off with a chisel and hammer :-X
Then a 13mm socket hammered onto it to take it out fuul way...
Logged
Reply #3December 17, 2009, 12:06:18 pm

burn_your_money

  • Global Moderator
  • Veteran
  • Offline
  • ****
  • 8999
  • Personal Text
    Bright, On
Re: Pump Triangle Socket
« Reply #3 on: December 17, 2009, 12:06:18 pm »
What triangle bolt? There are 2 on the old pumps, and 2 on the TDI pumps but only 1 of them is the same. I highly doubt that the metalnerd one is the correct one.
Logged
Tyler
Reply #4December 17, 2009, 12:17:02 pm

burn_your_money

  • Global Moderator
  • Veteran
  • Offline
  • ****
  • 8999
  • Personal Text
    Bright, On
Re: Pump Triangle Socket
« Reply #4 on: December 17, 2009, 12:17:02 pm »
Don't forget your safety glasses :o
Logged
Tyler
Pages: [1]
« previous next »
 

S-PAutomotive.com