Author Topic: Has anyone ever found actual turbo shaft end-play specs? (Read 5727 times)

Vincent Waldon · « **on:** March 17, 2009, 04:34:20 pm »

I'm about to tear down one turbo and sell the other... and I'll like to be a bit more scientific than the usual "very little shaft end-play" in the ad.

I've done a bunch of googling etc but have yet to find a source of what the stock and wear limits are for the Garretts and KKKs we run... if anyone has a source I'd be very grateful!

Vince

the caveman · « **Reply #1 on:** March 19, 2009, 08:50:03 am »

Vince, i'm positive i've seen the info somewhere, because once when i was at VW we were trying to determine which turbo was good between 2 that were mixed up. In the end the difference was only 1mm or so ,but one was good and the other wasn't . I will dig through my literature in the next day or 2.
The info is out there somewhere.

clbanman · « **Reply #2 on:** March 19, 2009, 10:38:41 am »

I am not sure if there are different numbers for the VW versions, but most numbers I have seen for Garrett turbos on Volvos and others indicate maximum end play of .008" and max. radial play of .022".

zukgod1 · « **Reply #3 on:** March 19, 2009, 10:46:27 am »

I'll bet the guys at gpopshop.com would give you that info Vince.

I'm about to contact them about a k04 compressor for my car, just waiting for the 2 turbos I bought to show so I have the #'s they will ask for before I send the message.

Anyway Gerry has always been very helpful to me.