My new T/D 1.6 in my Rabbit runs fine but I notice I have to crank for about 15 seconds before it will start even when warm. I have the timing at 1.0 m/m and I cleaned and lapped the injectors when I put it together and it runs great other than the long cranking speed, pump wasn't touched as far as the settings. I took the injectors out today to swap them with my N//A ones and did a compression test at the same time. I have between 450 and 475 psi on all cyls. after 15 pumps on each one so the comp. is fine. I noticed when I took the injectors out that one of them is a 130 bar one and the other 3 are 155's. I put the N/A 130's in from the other engine and it seems to start a litte quicker but has a lot more smoke than the 155's did and don't have the power they do either. I need to either get 4 new injectors or at least 1 and have them all rebuilt and pop tested. I guess the best thing is to do is get it all at the same place so they will alll be the same. I've seen these injectors for $50 appeace at a few sites rebuilt but I don't think most of those are actualy pop tested too though. Anybody have any recomendations for where to get this done or parts to do it here in the States, I live in Md. And again I am afraid of the Chinese stuff. Does anybody know about what Giles injectors run, nothing exotic, just rebuilt and pop tested.
Topic: Hard to start new T/D (Read 1860 times)
