« previous next »
Pages: [1]

Author Topic: Timing a non-turbo 2.4 (VW engine ina Volvo)  (Read 2250 times)

July 07, 2005, 10:30:59 pm

jackbombay

  • Veteran
  • Offline
  • ***
  • 599
Timing a non-turbo 2.4 (VW engine ina Volvo)
« on: July 07, 2005, 10:30:59 pm »
I was wanting to know what the correct lift at TDC for this engine (84') .

  I have a manual for the Audi 5 cylinder Diesels and for the non-turbo it says .80-.90 mm, I assume this is very close if not correct for the Volvo 2.4. My gauge is not metric and I will be shooting for the advanced end of the spectrum, .035".  I assume that finding TDC on this motor is similar to the Audi 5 banger that I have, a notch missing from the bell housing on the drivers side that lines up with the mark on the flywheel, can anyone confirm this?
Logged
Reply #1July 09, 2005, 08:10:56 pm

jackbombay

  • Veteran
  • Offline
  • ***
  • 599
Timing a non-turbo 2.4 (VW engine ina Volvo)
« Reply #1 on: July 09, 2005, 08:10:56 pm »
Anyone?
Logged
Reply #2July 10, 2005, 01:54:49 am

vwmike

  • Authorized Vendor
  • Veteran
  • Offline
  • ***
  • 1158
Timing a non-turbo 2.4 (VW engine ina Volvo)
« Reply #2 on: July 10, 2005, 01:54:49 am »
I wish I could help, but I have no idea what ths epecs are for that engine.
Logged
Pages: [1]
« previous next »