Ok, i mentioned on another post that my alternator belt was slipping. I've tightened it as much as i could, and took it for a drive. Well, the tach was bouncing around a bunch, and would go completely to zero when i step on the brake. At 60mph, it was hanging around 2000-2400rpm. But, when i turned on my turn signal, the tach went from whereever it was to zero, then back to where it was, then back to zero, in time with the turn signal. I turned on the headlights and it went to zero and stayed there. It's not done this before. The only reason i'm messing with it is because the alternator belt broke, and i had to come up with one to fit. It's TIGHT on there, the Water pump/crank belt is a little loose, but not bad. I'm out of ideas on this! Thanks for any help!!!!