Author Topic: Almost There!!!! (Read 2706 times)

Riverfurm · « **on:** August 26, 2007, 11:52:38 am »

Almost ready to swap out the 1.6 NA for a for a Turbo 1.6 in my 86 Golf.
Turbo engine is from a 85 Jetta with solid lifters and a Garret turbo with about 30,000 miles on it. So far it has a Giles pump, Passenger 3"down pipe,boost gauge,egt gauge(installed sensor before turbo), pop off valve on intake has been shimmed shut and a boost control valve.

PM items, valve adj.,pump timing,timing belt, water pump, belts, clutch & prs plate replace

Items left... block heater and likage kit for shifter and trip to the exhaust shop.

Can anyone think of something elese?

?

bert · « **Reply #1 on:** August 26, 2007, 12:21:46 pm »

Latex gloves keep your hands clean :wink:
Bert

Riverfurm · « **Reply #2 on:** August 26, 2007, 12:33:46 pm »

Got them...Plus prs. clean old engine :!:

numbnuts · « **Reply #3 on:** August 26, 2007, 12:51:40 pm »

A nice set of brakes!

Vincent Waldon · « **Reply #4 on:** August 26, 2007, 02:40:45 pm »

Everything good on transmission side.... both seals, clutch, pilot shaft seal, throwout bearing, flange bearings ?? Heck of a lot easier to change things now than later !!

Motor mounts in good shape ??

CV joints OK ??

Black Smokin' Diesel · « **Reply #5 on:** August 26, 2007, 04:32:43 pm »

Good time to replace all the shifter bushings. It's a PITA to do with the engine in.

Riverfurm · « **Reply #6 on:** August 28, 2007, 02:49:44 am »

Allso have new motor and trans mounts. And shifter bushing kit coming.